User manual

INSTALLING BUILD PLATE

--------------------------------------------------------------------------------------------------------------------------------------------

4. Installing the Build Plate

Never tear off the yellow kapton

tape on the aluminium plate. You

can either put the silicon glass onto

the platform to make the build plate

perfect flat or without silicon glass

plate(for freshman recommended).

Please adjust the 4 knobs under HBP

to re-level the heating plate if you are

adding the silicon glass plate. Wanhao

masking tape is used for both ABS and

PLA printing which can make filament

stick to the platform easier.

5. Freeing the Extruder

A. Use strong scissors or a wire cutter

to cut the zip ties holding the gantry

system in place. Discard the zip ties

and the plastic pieces holding them

in place.

NOTE: Operate scissors with care.

B. A small plastic piece attached to the

X-axis belt and gantry rods prevents

the extruder form moving. Carefully

snap the piece off of the rods and

tilt it to slide if off of the belt.

SETTING UP YOUR WANHAO DUPLICATOR 4/4x DESKTOP 3D PRINTER

---------------------------------------------------------------------------------------------------------------------------------------

--------