User’s manual ：WY50QT-7
PREFACE Thank you for buying king's wild Model WY50QT-7 motorcycle, meanwhile, welcome you to join the ranks that king's wild motorcycle drives sincerely. Unless it enjoy it is the safer for driving result happy, before driving,should first contained every content in manual familiar completely. Your personal security, does not only depend on your alertness and is familiar with every operating technology, whether familiar with mechanical performance of the motorcycle relevantly with you too.
maintains tools, then the special agencies of all parts can offer the accessories catalogue and traditional accessories, help you to do a god job in multiple maintaining and repair work. Operation instructions this adjust Model WY50QT-7 correct working technique with simple maintenance of motorcycle method, main point,etc. explain, expect durable to use in detail.
Important attentive matters • Driver and passenger The design of this type motorcycle, the limit is for a driver to use. Don't exceed the load quality of this car stipulating on this manual absolutely • On the basis of the consideration of the safety factor, abominable climate environment and cold weather (- under 12 ℃), try not to drive the motorcycle. • Road surface condition • The design of this type motorcycle, is only limited to going on the highway.
LIST Ⅰ.Motorcycle safe drive Rules for safe drive …………………………1 The payload …………………………………1 Ⅱ. The location of the vehicle and use the map Parts & subassemblies…………………………2 Meter and indicator light………………………3 Ignition switch………………………………3 The fuel meter…………………………………3 Flameout switch………………………………3 The starting switch……………………………3 The head light change switch…………………4 The turning light switch………………………4 The horn switch………………………………4 The turning lock………………………………4 The seat lock…………………………………4 Props box ………………………………… 4 Ⅲ.
Ⅰ Motorcycle safe drive Rule for safe drive 1. The motorcycle happens many accidents; all reasons are that the car drivers didn’t look at the motorcycle drivers. So the motorcycle drivers must: 2. l Put up the coat in bright color. l Avoid driving at night. You must drive on guard and carefully to the strong light. Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the automobile lane. 3.
Ⅱ.
The broken line（……）indicate the parts unseen in the picture Instrument and turn signal light（Fig3） ⑴ engine tachometer Fig3 ⑵ turn left signal light ⑶speedometer ⑷high beam signal light (5)mileometer (6)turn right signal light (7)fuel meter Ignition switch（Fig4） ⑴Open( )—when the switch turn to this position, start engine and don’t take out the key. ⑵Close( )—when the switch turn to this position, start engine power off and take out the key.
Press this button, the engine is started.（See Fig14） The front light change switch 1（Fig7） Press“ ”button，to get high beam；Press“ ”button，to get low beam Turn signal light switch 2（Fig7） When the switch is on“ ”turn left，When the switch is on“ ” button, turn right. Press it down the light turn off. Horn switch 3（Fig7） Press switch, the horn make sound. Fig 7 Steering lock（Fig 8、Fig 9） Turn handle left to end, press down ignition key to （ ）,the steering setting are locked.
the same time; ,Can close the previous storage tank. NOTICE: Ÿ The articles exceeding 1kg in weight, don't put into incidental case. Ÿ Don't adjust the incidental case well to spray with water of pressure, otherwise, leave in the storage tank water stainly before making Ÿ Don't close in the air flow trough. Ⅲ. Operation instruction Inspection before riding For safety and preventing trouble or accident, pre-check up is necessary.
Suggested engine number: SAE-15W/40 The free path of rear brake handle（Fig 14、Fig 15、Fig 16、Fig 17） Measure the distance of rear brake pedal before detent function, The free path should between 10-20mm, take the tail of brake handle as standard. • Adjust nut： （A）increase the distance of free path. （B）reduce the distance of free path After adjust, the axle pin (2) should touch closely with nut (1) groove after adjust.
• Ÿ It is dangerous to use the worn tire, it will effect to the friction between tyre and road. It will possibly bring trouble or driving or even an accident. Start engine (Fig 19) • Put the key into ignition switch and turn to “ ”. • Electric starter: press start button (1) to start engine, DO not use the starter more than 5 seconds each time. NOTICE： • Electric starting is only in the condition of grasping the brake handle.
Speed according to 2： Table2 Log（km） 0～200 200～500 500～1000 ≤30 ≤45 ≤55 Speed (km/h) Riding operation • Release rear brake lever: • Add gasoline slowly with throttle grip and then motorcycle will move forward smoothly. NOTICE: • Do not add much gasoline suddenly with throttle grip to prevent motorcycle rush out unexpectedly. • Before drive, driver must take the stand. Brake operation: 1.
Stop operation: When the motorcycle stop, put the key to（ ）position, put down stand and lock handle.（See P7） Admonition：Park the motor in a smooth ground, or it may fall down and cause injuring. Alarm points： • Locking the handle and do not left key in the switch. • Put the motor into the garage. • Use the excellent guard against theft device. Ⅳ Maintenance and service Maintenance periodic form The maintenance is important to motorcycle.
Cyc Item 1 ﹡ ﹡ Rotate the belt Gearbox engine oil ﹡ ﹡ ﹡ ﹡ ﹡ Brakes system Brake cock Head light Hanging system The nuts\bolts a 紧tyre Wheel Turning bearing （Note3） （300km）R I （Note2） I I Add table3 speedometer（×1000km） Ref 4 8 12 page C/1000km, if need:R I 26 I I I 11 I I I I I I I I I I I I I 13 I ﹡If you have all of tools and maintenance document, you are a mechanic person, or else must let special person maintenance and repair ﹡﹡For safety, we claim all of items have been done by mechanic pers
Trouble phenomenon The vehicle is unable to accelerate performance badly The electricity is started and does not work Riding unsteady Apply the brake and does not work Trouble reason The octane value of the fuel is too low Oil path stop up Ignition tie is too early or too late Spark too weak or flameout Mixed air too dense or race Engine leak Muffler stop up Belt wear out The automatic clutch roller wearing Consult engine can not start solution Change flue Clean oil path Check wire and change CDI Check
terminal first and positive terminal next, when installing, just opposite to above procedure Adjustment of idle speed（Fig24、Fig25） The carburetor has adjusted to the best situation before selling out. If it is not well adjusted, ask professional to adjust it as the following instruction.
then start the engine. l Remeasure the oil mass. Make sure the oil mass is near to or in the mark of upper limit without leakage. Gear oil change（Fig 27） Suggested oil octane number： SAE 80W/90（you can use prevent frostbite oil in very cold area） Oil capacity Resolving capacity: 0.11L Changing capacity: 0.09L • Place the vehicle by the main stand. • Screw out the immersion bolt 1 and oil-drain bolt 2. • NOTICE：When leak, the engine need a certain temperature, Fig27 the motor use main stand.
short circuit or overload in the electric system. Ask the serviceman to repair it, and never use the brass wires to replace the fuse. Ⅴ.Vehicle Storage STORAGE For the motorcycle not to be used for a long time, some steps should be taken to prevent malfunction and damage to the parts. Besides, before the long-time storage, proper repairs should also be done. • Change the engine oil. • Drain out the fuel in the fuel tank and carburetor.
Ⅶ. Tool Toolbox（Fig29）is placed in the luggage box under the saddle, and toolbox contains the following tools: Wrench 8x10mm Wrench 12x14mm Screwdriver Hexagonal wrench Handle of screwdriver Sleeve wrench 18.5x17 Fig30 Ⅷ.
Add table5 Item Lubricating Way Rated Power Parameter Press and splash Item Parameter Fuse 15A 2.2kw/7500r/min 12V 18W/18W×2 Headlight Max Torque 3.0N.m/7500r/min 12V Compression Ratio Tail 10.5∶1 Light/Brake light/license plate light Spark Plug Spark Plug Gap mm Idling Speed r/min Capacity 0.8L Ignition way mm or License Plate Light Turning light Fuel Brand 12V 5W/21W 12V 5W 12V 10W×4 RQ93 Above Capacity of gearbox of Crankcase oil Valve gap C7HSA(NGK) A7TC、A7RTC 0.6～0.
Ⅹ.Emission Control System Warranty Statement Wangye USA Co., LLC is pleased to explain the emission control system warranty on Highway Motorcycle. New Highway Motorcycle must be designed, built and equipped to regulations and standards of the United States Environmental Protection Agency and the California Air Resource Board and free from defects in material and workmanship that may keep it from these requirements in the all applicable regulations. Wangye USA Co.
(iii). Damage as a result of accidents, collisions, contact with foreign materials, impact, submersion or use of the motorcycle after discovery of a defect; (iv). Appearance-related damages of body parts. Examples of such damages include but are not limited to: scratches, dents, fading, flaking and peeling; (v). Motorcycle which has been modified in any way from the standard specifications shown in the Owner’s Manual, for example, the odometer has been altered; (vi).
