User manual

- 25 -

Replacing gearbox oil（Fig 26）

Suggestion gearbox oil :

SAE 80W/90（North Cold Area use anti-freezing oil）

Oil container

Resolving capacity：0.11L

Replacing capacity ：0.09L

• Make the motorcycle on the Stand

• Take apart the immiting bolt (2), and the spilling bolt (1).

NOTICE: The engine must be warmer when

spilling and the vehicle must be steady by main

stand. Make sure the Engine is empty

• Reinstall the spilling bolt after clean. And screw up.

• Inject 100ml to engine through immit bolt

• Install immit bolt and screw up.

Fig26

2 1

- 26 -

SPARK PLUG（Fig 27）

Specification of Spark Plug： BPR7HS ,BP7HS (NGK), E7TC , E7RTC

• Disconnect the spark plug cap, and then use the special handle to remove Spark plug.

• Check if the spark plug electrodes and the center porcelain

head burned, accumulative carbon, etc. If the spark plug

is burned out, replace new spark plug

Use spark plug cleaner to clean the deposits, or use a wire brush.

Adjust the Spark Plug gap between（0.6～0.7）mm.

• Don’t use an unspecified spark plug.

Replacing fuse

The specified electric current of the total fuse is 15 A, which is in Battery.

If the connection is not good, the fuse will overheat and breakdown.

Do not use brass wires to replace the recommended.

(0.6～0.7)mm

Fig 27