User manual

- 23 -
Cleaning Air FilterFig 22
Take apart the bolt of air filter cover.
Take out filter element
Compress air or use dry brush to clean filter
element.
Do the above opposite to reinstall the air filter.
NOTICE:
Do not use gasoline or low burning point solvent to clean paper filter element.
Battery maintenanceFig 23
It is Adopted the airtight battery (dont add water)
Notice: Do not take apart the airtight
If the motorcycle have not been used for a long time.
Taking off the battery and putting it into a dry and place.
The head of battery was corroded, please take it off and
clean. (Can use boil water)
NOTICE: turn off the ignition switch, take apart negative pole
-
first, but install positive pole
+
when you are installing.
Fig23
Fig 22
- 24 -
Adjusting idling speedFig 24, Fig 25
The carburetor is in the best situation before sale, if the carburetor is still
influence riding. Please adjust it under the instruction of professional man.
Warm up few minutes before start
adjust Idle screw (1) to improve idle speed slightly to enter to
fasten, Withdraw it than screw slowly after stocking to fasten
to mix and then rapidly, to stabilizing the position at most,
then withdraw slowly, get and stabilize the position the most
low.
After adjust idle, then adjust accelerograph handle to
free path for 2-4mm,then use adjustor (2) to adjust, screw
down nuts, and then screw up it after adjust.
Adjusting the idle speed, it should be able to suddenly
strengthen the throttle, the rotational speed of the engine
should be excessively steady, no temper and flameout, stop
working or arrange organ not to flameout at being last throttle.
Fig24
Fig25