User manual

13
Starting engine (Fig 17)
• Preparative before starting：Set up the Main Stand，Put
the key into ignition switch and turn to “ .
Electric starter：Press start button (1) to start engine, DO
not use the starter more than 5 seconds each time.
NOTICE:
Electric starting is only in the condition of grasping the brake handle.
Electric starting not succeed, if starting again with it, we must stop for 30 seconds, If still
can’t start, Please use kick-start.
Engine kick-start :open ignition switch and add gasoline slowly, step kick-starter pedal
down quickly with strength to start engine.
Notice: After using kick-starter pedal, pull it back to original position. Otherwise
have effect to safety ride, and bad to engine.
Had better not open ignition switch when scooter has not use for a long time, and first
step kick starter for some times. Make flue into carburetor and then into cylinder, and
open ignition switch, Start engine, it is easy to start engine like this.
If cold start warm up engine for 2-3 minutes.
Fig17
14
Driving motorcycle:
WARNING:
Wear the trousers to avoid touching with exhaust pipe and was burnt.
The entire device must be installed according to requirement of the
traffic rule.
Take the license to riding.
NOTICE:
Control the speed and load during 1000km of running in period. Load should
be within 100kg(including driver) If take more weight and speed will reduce
life of engine,
Speed according to (Table 2)
Table 2
Leg（km） 0～200 200～500 500～1000
Speed
(km/h)
≤20 ≤30 ≤35