User manual

Spark plug (Fig 26)

Specification of spark plug:

BPR7HS ,BP7HS (NGK), E7TC , E7RTC

• Take apart the spark plug; Take it of with special tool.

Examine if there is dirty on poles and the

porcelain head in center .If it has corroded, must

change it .It is the best way to clean with the liquor

of spark plug Use wire brush if no cleaner

• Normally the gap between side electrode (1) and

Center electrode (2) is 0.6-0.7.

• Don’t use other spare plug.。

Replacing fuse

The specified electric current of the total fuse is 15 A

If the connection is not good, the fuse will overheat and breakdown.

Do not use any fuse whose specification is different from assigned. It is the same

Main reason for wiring burning.

NOTICE: Do not use brass wires to replace the recommended.

(0.6～0.7)mm

Fig26

Ⅴ.Vehicle storage

Storage

For the motorcycle not to be used for a long period of time, for example, in wintertime, some

steps should be taken to prevent malfunction of and damage to its components, which might be

caused by long storage. Besides, before the long storage, proper maintenance has to be carried

out for fear that it might be forgotten when vehicle is put back into use after storage.

1. Change engine oil and oil filter.

2. Drain off fuel from the fuel tank and carburetor, spray atomized anti-rust oil onto the inside wall

of the tank and then close the tank.

Warning: Gasoline is inflammable and may cause fire and even explosion under certain conditions.

Therefore, do not smoke, make fire or have any fire left behind on draining off fuel.

3. Take out the spark plug, pour about 15~20ml clean engine oil into the cylinder, step down the

kick lever repetitively for several times so as to have machine oil distributed all over the engine

and finally fit the spark back on.

Attention: The ignition switch must be set to ”OFF” position before stepping down the kick lever. To

protect the ignition system from damage, the spark plug should be inserted in its cap and

earthed.

4. Wash the motor, wipe it dry and apply an even coat of wax to the painted surface. Chromate

treatment can prevent the surfaces from rusting.

5. Inflate the tires as required and pad the vehicle up by wooden blocks with the two wheels

clearance of the ground.

6. Put the vehicle in a shady and cool place free from humidity and direct sunshine and cover it

properly (but not with plastic or other painted materials).

Reuse motorcycle.

Clean the motorcycle, if the storage time beyond 4 months, Must change gasoline.

Must charging if need, and then install battery.

Must check all of terms before drive (Page 9), for the safety must try the motorcycle with lower

speed for some time in a not busy rode.