User manual

Adjusting Idling speed（Fig 22, Fig23）

The carburetor is in the best situation before sold, if the

carburetor is still influence riding

Please adjust it under the instruction of professional man.

• Warm up few minutes before start。

• Idle to adjust screw (1) is it is it improve idle speed slightly to

enter to fasten, is it is it

Withdraw it than screw slowly after stocking to fasten to mix

and then rapidly, to stabilizing the position at most, then

withdraw slowly, get and stabilize the position the most low.

• After adjust idle, then adjust accelerograph handle

to free path for 2-4mm,then use adjustor (2) to adjust,

screw down nuts, and then screw up it after adjust.

• Adjusting the good idle speed, when should be able to

suddenly strengthen the throttle, the rotational speed of the

engine should be excessively steady, no flash back and can't

go out, stop working or arrange organ not to blow out at being

last throttle.

Fig 22

Fig23

Replacing gearbox oil (Fig 25)

Suggestion engine oil No: SAE 80W/90

Oil container

Resolving capacity：0.11mL

Changing capacity ：0.10 mL

• Make the motorcycle on the Stand

• Take apart the immiting bolt (2), and the spilling bolt (1).

NOTICE: The engine must be warmer when

spilling and the vehicle must be steady by main

stand. Make sure the Engine is empty

• Reinstall the spilling bolt after clean. And screw up.

• Inject 100ml to engine through immit bolt

• Install immit bolt and screw up.

Fig 25