User manual

15
Driving operation
Release rear brake level, add gasoline slowly with throttle grip, then motorcycle will
move forward smoothly.
NOTICE:
Do not add much gasoline suddenly with throttle grip to prevent motorcycle rush out.
Maybe lose control.
• Before drive, must take the stand.
Braking operation:
1 Control throttle grip
If want to reduce speed, Must control the throttle grip, at that time use the two-brake
system, this point is very important.
Notice: if the drive will be done in this situation, for example: damp or loosely
roads, raining .no matter brake, add speed or turn must take care.
2.operate front and rear brake.
Notice: Must totally close the flue when drive in a descent, and use two-brake
system for reduce speed. Don’t use brake continuously, other wise it will reduce
the effect of brake because of too hot.
Warning: Don’t use single brake when drive with high speed, special crooked and
slippery road. Must use two-brake system for avoiding accident.
16
Engine power off operation （Fig18, Fig19）
Turn off Throttle：Revolve to the lowest place according to picture. (Normal situation is
loose the throttle grip, and the engine is idling speed)
• Put the key to “ ”
Stopping operation:
When the motorcycle stop, put the key to “ ” position .put down stand and lock handle.（Ref P7
Warning：Motorcycle should be park on the Solidity and Flat ground, otherwise, it maybe
make some body injured or vehicle down
Alarm points:
1 Locking the handle and do not left key in the switch
2 Put the motor into the garage
3 Use the excellent guard against theft device
Fig19
Fig18