USER MANUAL Motorcycle Operating Manual Model: WY50QT-30A PREFACE Thanks for your purchasing the motorcycle WY50QT-30A, and sincerely welcome you to be our motorcycle user. To enjoy a more safe and pleasurable driving, at first please familiarity with the manual must carry on before driving. Your personal safety depends not only the vigilance and familiar operation skills, but also relates to whether you are familiar with the mechanical performance.
The important points to attention Ÿ The driver and passenger This motorcycle was limited to one driver and one passenger (except children younger than 12 years old). Never exceed the Max load capacity of motorcycle. Ÿ For the safety, avoid driving the motorcycle in atrocious weather or cold weather (under -12℃). Ÿ For the road condition This kinds of motorcycle can only drive on the highroad.
Ⅰ. Motorcycle safe drive Rules for safe drive 1. The motorcycle happen the many accident, all reasons are that the car drivers didn’t look at the motorcycle drivers. So the motorcycle drivers must: l Put up the coat in bright color l Avoid to the driving at night .you must drive on guard and carefully to the strong light. 2. Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the automobile lane. 3.
Ⅱ.Parts&Subassemblies and use instruction Parts&Subassemblies (Fig1.Fig2) Fig.
Meter and indicator light （Fig3） ⑴Odometer ⑵Speedo meter ⑶Fuel meter ⑷Parking light ⑸Right Turning signal light ⑹Voltage Meter ⑺Left Turning signal light (8) High-Low beam light ⑼Time meter Fig3 Ignition Switch（Fig4） (1) On ( )-when the switch turn to this position, Start engine and do not pull out the key.。 (2) Off ( ) When the switch turn to this position, Start engine power off and take out the key. ⑶ Lock ( ) When the switch turns to lock position ( ), Take out the key .
Main beam switch (1)（Fig 7） Press“ ”button，is main beam；Press“ ”button isdipped beam。 Turning signal light switch (2)（Fig 7） When the switches on ( ) ,the left turning signal light turn on. When the switch on ( ), the right turning signal light turn on, Press it down the light turn off. Horn Switch (3)（Fig 7） Press this button, the horn makes sound.
Ⅲ.Operation guide Checking before driving: For safety and prevent trouble or accident, Pre-check up is necessary. Fuel When the pointer or fuel meter is close to red section, replenish oil; meanwhile, check the Fuel Tank and Carburetor rack or not Fuel Tank：7.5L • Clock –wise to open the tank cover.（Fig 11） • Suggestion gasoline: octane number is 90 • Do not replenish gaoline together with tidy or water NOTICE: Fig 11 If check gasoline volume or replenish gasoline soon after stop, Beware of burning.
Free Path of Rear Brake（Fig 14,Fig15） Measure the distance of rear brake pedal before detent function .the free path should between 20-30mm, take the tail of brake handle as standard. Fig14 Fig15 11 Tire Check the tire pressure regularly and adjust. Check before the tire cooled Check if there any metal trash or gravel in the groove of tires WARNING: If the tire pressure dose not accord with the standard, it will properly cause the traffic accident.
Starting engine (Fig 17) • Preparative before starting：Set up the Main Stand，Put the key into ignition switch and turn to “ . Electric starter：Press start button (1) to start engine, DO not use the starter more than 5 seconds each time. NOTICE: Electric starting is only in the condition of grasping the brake handle. Fig17 Electric starting not succeed, if starting again with it, we must stop for 30 seconds, If still can’t start, Please use kick-start.
Driving operation Release rear brake level, add gasoline slowly with throttle grip, then motorcycle will move forward smoothly. NOTICE: Do not add much gasoline suddenly with throttle grip to prevent motorcycle rush out. Maybe lose control. • Before drive, must take the stand. Braking operation: 1 Control throttle grip If want to reduce speed, Must control the throttle grip, at that time use the two-brake system, this point is very important.
Ⅳ.Service and maintenance Maintenance periodic form The maintenance is important to motorcycle, If drive with high speed in bad situation for a long time, must add the times of maintenance, If motorcycle have a big repaired or a accident, Must take it to check for mainly spare parts. For example: frame, indicator parts and so on. Repair or change the worn parts. Make sure safety. Notice: Don’t change motorcycle make sure it’s safety, Must use good quality spare parts if replace spare parts .
Blank3 Cycle 1 Item Every month ﹡ Transmission belt ﹡ Gearbox oil Brake system Brake Switch Headlight ﹡ Suspension ﹡ ﹡ Bolts&Nutsfasten Wheel, Tyre ﹡ Turning bearing ﹡ Speedometer（×1000km） 4 8 12 Ref Page 6 12 18 Per1000km I Note3 （300km）R I I I I I I Note2 I If need: R I I I I I I I I I I I I I I 25 11 12 *If you have all of tool and maintenance document, you are a mechanic person, or else must let special person maintenance and repair.
Table 4 Complaint The vehicle is unable to accelerate performance badly Symptom and possible causes Change fuel Oil path stop up Clean oil path Ignition time is too early or too late Check coil and change CDI Spark too weak or flameout Check ignition and clear out Mixed air too dense or race Clean& adjust carburetor Engine leak Check and clear out Muffler stop up Dredge Belt wear Turning bearing gap too wide Replace Replace Replace Replace Charge Adjust Lack of tire pressure Pump Front&
Adjusting Idling speed（Fig 22, Fig23） The carburetor is in the best situation before sold, if the carburetor is still influence riding Please adjust it under the instruction of professional man.
Spark plug (Fig 26) Specification of spark plug: BPR7HS ,BP7HS (NGK), E7TC , E7RTC • Take apart the spark plug; Take it of with special tool. Examine if there is dirty on poles and the porcelain head in center .If it has corroded, must change it .It is the best way to clean with the liquor of spark plug Use wire brush if no cleaner • Normally the gap between side electrode (1) and Center electrode (2) is 0.6-0.7. • Don’t use other spare plug.。 1 (0.6～0.
Ⅵ.Vehicle identification Vehicle type, Code and trademark of the bikes（Fig27） When the bikes are registered or getting the license from the transport department, the owner should be send the VIN number and engine number。The maintain people change the parts, need the numbers too. The products brand should be added at the right side plate of the Main stand（see P3）. Fig27 Ⅶ.
Table 5 Item Data Item Spark plug gap mm Idling speed r/min Engine oil L Fuel 0.6～0.7 Ignition System (1800±180)r/min Special 2T oil (FC level) Gearbox oil Capacity of engine oil 1.2L Capacity of gearbox oil 29 Ⅸ.Circuit 30 Data RQ90 above CDI SAE 80W/90 0.
Ⅹ.Emission Control System Warranty Statement Wangye USA Co., LLC is pleased to explain the emission control system warranty on Highway Motorcycle. New Highway Motorcycle must be designed, built and equipped to regulations and standards of the United States Environmental Protection Agency and the California Air Resource Board and free from defects in material and workmanship that may keep it from these requirements in the all applicable regulations. Wangye USA Co.
(viii). Damage from theft, fire, vandalism, explosion, water or acts of God. 4. Restriction This warranty is in addition to, and not a modification of, any legal warranty required by the laws of any state of US.
