User’s manual ：WY50QT-10 PREFACE Thanks for your purchasing the motorcycle WY50QT-10, and sincerely welcome you to be our motorcycle user. To enjoy a more safe and pleasurable driving, at first please familiarity with the manual must carry on before driving. Your personal safety depends not only the vigilance and familiar operation skills, but also relates to whether you are familiar with the mechanical performance. Before driving, check-up and periodical maintenance are basic requirement.
The important points to attention Ÿ The driver and passenger This motorcycle was limited to one driver and one passenger (except children younger than 12 years old). Never exceed the Max load capacity of motorcycle. Ÿ For the safety, avoid driving the motorcycle in atrocious weather or cold weather (under -12℃). Ÿ For the road condition This kinds of motorcycle can only drive on the highroad.
Ⅰ. Motorcycle safe drive Rule for safe drive Only the driver can be sure the motorcycle safety. 1、 The motorcycle happens many accidents; all reasons are that the car drivers didn’t look at the motorcycle drivers. So the motorcycle drivers must: ※Wear the bright color clothes. ※Avoid driving at night. You must drive on guard and carefully to the strong light. 2、 Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the automobile lane.
II. The parts & subassemblies and use manual Parts & subassemblies（Fig1、Fig2） Meter and light Fr .Brake handle luggage battery Production Label Main stand Fig 1 -3- rr.
2 Meter and indicator light（Fig3） 1 4 5 ⑴ Odometer：Records vehicle mileage。 ⑵Speedometer ：When the vehicle, the speed of the vehicle。 ⑶Fuel Meter：Show gasoline stocks。 ⑷ Right Turning indicate light：When turning lights when clicked, right button right turn indicator will 6 shine。 ⑸Headlight indicate light：Variable light switch button in the “ ”, high beam light will shine。 ⑹Left Turning indicate light：When turning lights button when clicked, left turn indicator will to shine。 2 Ignition Switch（Fig4
High-Low beam switch 1（Fig7） Press “ ” button，to get high beam；Press“ ”button，to get low beam. Turning light switch 2（Fig7） When the switch is on“ ”, turn left; When the switch is on“ ” button, turn right. Press it down the light turn off. Horn switch 3（Fig7） Fig 7 Press this button, the horn is sounding. Turning lock（Fig8、Fig9） Turn handle left to end, press down ignition key to （ ）,the steering setting are locked. Doing the above opposite, it is unlocked.
III. The operation ·Inspection before riding Make routine check-up before riding to insure the vehicle perform well and safe driving. Gasoline volume Turn on the ignition switch and check the fuel meter, replenish gasoline when the pointer is close to red section, moreover, check the fuel tank and oil filter if leakage. • Gasoline tank container：5L • Counter-Clockwise to open the tank cover.（Fig12） • Proposal Using low lead content or gasoline, octane number is 90.
The free path of rear brake handle（Fig14、Fig16） Measure the free path of rear brake handle before the detent function. The free path should be within （10～20）mm from the end of brake handle to calculate. • Adjust nut： （A）Increase the free path. （B）Decrease the free path. After adjust, the axle pin (2) should touch closely with nut (1) groove after adjust. 1 2 Fig14 Fig15 - 11 - Abrasion mark of the brake（Fig16） （1） Reference marks （2） Indicate marks. If totally brake.
2 Fig16 Tyre Check the tyre pressure periodically and adjust it if necessary. • Check the tire pressure only when it is cooled. • Check if there any metal trash or gravel in the groove of tyres，repair the tyre if leaking. • Check if any metal trash or gravel in the groove of tires. If any impair please show your motorcycle to the maintain service to inspect. • Replace the tire when it wears to the abrasion mark.
Drive the motorcycle: WARNING: • Wear the trousers to avoid touching with exhaust pipe and was burnt. • All the device must be installed according to requirement of the traffic rule. • Take the license to ride. • Each equipment of the motorcycle should accord with the traffic law of local government。 Control the speed and payload during the first1000kmPayload among75kg is appropriate (including driver) overtaking and overloading will shorten the life of engine.
Stopping engine（Fig 19、Fig 20） • Close oil: revolve to the lowest place according to picture. (Loosen the throttle grip in normal situation, and the engine is under idling speed mode) • Turn the ignition switch to （ ） Fig18 fig19 Stop operation: ）position, put down stand and lock handle（refer to When stop the motorcycle, put the key to（ page 7） Admonition：Park the motor in a smooth and hardy ground, or it may fall down and cause injuring.
Maintenance periodic table（Table3） Check before driving must be conducted while periodical maintenance (refer to page 9) I: Check-up and adjustment if needed.
Obviate the simple trouble（Table4） Trouble Phenomenon Trouble reason Spark plug no spark The spark is weak Engine Cant start Table4 No mixed air in cylinder The cylinder compresses strength low Solution Spark plug wear out Ignition wire wear out CDI wear out Ignition switch wear out Ignition come off or become flexible Spark plug gap too small or big Spark plug pole burn The spark plug accumulates carbons seriously No spark to consult the spark plug No fuel Oil mouth stop up Fuel tank pressed the sw
Cleaning air filter（Fig 20） • Take out air cleaner cover • Screw up the blot. • Take apart the core from air cleaner box. • Compress air or use dry brush clean the filter element or put a new filter in the air clean box. • Do the above opposite to reinstall the air filter. NOTICE： • Fig 20 Do not use gasoline or low burning point solvent to clean。 Battery service（Fig 22） It is adopted the airtight battery (don’t add water) NOTICE：Never take apart upper cover of the electrolyte.
oil replacement、Machine oil oil filler strainer's clean Change the oil（fig25） When replaces the machine oil, should when engine's temperature not yet cools, the automobile body carries on by the jiffy stand support reliable condition, guaranteed that fast and complete puts the machine oil clean 。 • Machine oil oil filler strainer's clean • Preoccupies gets off an aircraft the oil dipstick and located at the engine base oil filter cover 1, after taking down the oil filter cover, then takes down the oil filt
Changing Oil from Gear box（Fig25） Proposal Oil Trademark SAE 80W/90（Using prevent frostbite Oil in the Very cooled area） Oil capacity Resolving capacity：0.10L Changing capacity：0.09L Place the vehicle by the main stand. • Screw out the leaking bolt 1 and oil-drain bolt 2. Warning ： When leak, the engine need a certain temperature, the motor use main stand. Make sure all of 2 the oil is leaked. Fig25 • Clean the drain bolt and then re-install it.
Ⅴ.Vehicle Storage Stockpile For the motorcycle not to be used for a long time, some steps should be taken to prevent malfunction and damage to the parts. Besides, before the long-time storage, proper repairs should also be done. • Change the engine oil. Drain out the fuel in the fuel tank and carburetor. Warning: Gasoline is inflammable and may cause fire and even explosion under certain conditions. Therefore, do not smoke or make fire.
Ⅷ. Main technique Parameter Item Blank5 Parameter Item L×W×H mm Wheel Base mm Parameter 1690×645×1055 1195 Ground Clearance mm 135 Dry Weight kg 85 Max Payload kg 75 kPa Transmission Turning Angle of Steering Handle º ≤48 Battery 12V 4Ah Rear brake average reduction rate m/s2 Initial speedV=40km/h Front Tire Rear Tire 3.00-10 3.00-10 Pressure Front Tire kPa Pressure RearTire 180 200 Automatic CVT Front brake space m Front brake average 2 reduction rate m/s Rear brake space m ≤21.
Ⅸ. Circuit diagram - 33 - X. Emission Control System Warranty Statement Wangye USA Co., LLC is pleased to explain the emission control system warranty on Highway Motorcycle. New Highway Motorcycle must be designed, built and equipped to regulations and standards of the United States Environmental Protection Agency and the California Air Resource Board and free from defects in material and workmanship that may keep it from these requirements in the all applicable regulations. Wangye USA Co.
the Owner’s Manual; Give notice to dealer approved by Wangye USA Co., LLC or other qualified service facility of any and all apparent defects immediately upon discovery, and make the entire motorcycle available at the time for inspection and repair at the dealer’s place of business; (iii). Provide proof of warranty coverage to dealer; (iv). Authorize the dealer to tear down the motorcycle for diagnostic evaluation should it be required.
