前 言 PREFACE Thanks for your purchasing the motorcycle WY50QT-28A, and sincerely welcome you to be our motorcycle user. To enjoy a more safe and pleasurable driving, at first please familiar with the manual must carry on before driving. Your personal safety depends not only the vigilance and familiar operation skills, but also relates to whether you are familiar with the mechanical performance. Before driving, check-up and periodical maintenance are basic requirement.
The important points to attention Ÿ The driver and passenger This motorcycle was limited to one driver and one passenger (except children younger than 12 years old). Never exceed the Max load capacity of motorcycle. Ÿ For the safety, avoid driving the motorcycle in atrocious weather or cold weather (under -12℃). Ÿ For the road condition This kinds of motorcycle can only drive on the highroad.
Ⅰ. Motorcycle safe drive Rules for safe drive 1. The motorcycle happen the many accident, all reasons are that the car drivers didn’t look at the motorcycle drivers. So the motorcycle drivers must: l Put up the coat in bright color l Avoid to the driving at night .you must drive on guard and carefully to the strong light. 2. Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the automobile lane. 3.
Ⅱ. The parts & subassemblies and use instruction Parts & subassemblies (Fig 1.Fig 2) Fig 1 -3- Fig 2 Broken Line（……）indicate the invisible parts.
Speedometer and indicator (Fig 3) ⑴ ⑵ ⑶ ⑷ ⑸ ⑹ ⑺ engine speed LH turning signal light main beam indicator odometer speedometer RH turning signal light fuel meter Fig 3 ⑻ engine oil lower light Ignition switch（Fig4） (1) On ( )-when the switch turn to this position, Start engine and do not pull out the key. (2) Off ( ) When the switch turn to this position, Start engine power off and take out the key. (3)Lock ( ) When the switch turns to lock position ( ), Take out the key .
Main beam switch (1) (Fig 7): Press ( ) button is main beam; press ( button is dipped beam. ) Turning signal light switch (2)(Fig 7): When the switches on ( ) , the left turning signal light turn on; When the switch on ( ) turn, the Fig7 right turning signal light turn on; Press it down the light turn off. Fig7 Horn switch 3:（Fig 7） Press (3)this button, the horn makes sound.
Ⅲ Operation instruction Checking before driving: Checking before driving, for safety and prevent trouble or accident, pre-check up is necessary. Fuel capacity • When the pointer or fuel meter is close to red section, replenish fuel, meanwhile checking if there’s leakage • Gasoline tank container: 5L • Clock –wise to open the tank cover.
Free Path of Rear Brake( Drum Brake)（Fig 14,Fig15） Measure the distance of rear brake pedal before detent function .the free path should between 10-20mm, take the tail of brake handle as standard. • Adjust Nut： （A）Reduce Free Path。 （B）Increase Free Path When adjust, the Pin 2 and Adjust Nut1 should impinge on Note: Rear Disk brake is available, but can’t adjust Free Path. When you can’t see Disk brake oil, please immit the disk brake oil.
Tire Check the tire pressure regularly and adjust. Check before the tire cooled Check if there any metal trash or gravel in the groove of tires WARNING: If the tire pressure dose not accord with the standard, it will properly cause the traffic accident. It is dangerous that use the worn tire, It will have effect to friction between tire and rode. Maybe make difficult from drive or accident.
WARNING: Wear the trousers to avoid touching with exhaust pipe and was burnt. The entire device must be installed according to requirement of the traffic rule. Take the license to riding. NOTICE: Control the speed and load during 1000kmof running in period. Load should be within 100kg(including driver) If take more weight and speed will reduce life of engine, Change the crankcase oil after 300km (Page 25) to a new motorcycle.
Engine Power off operation（fig20、fig21） Close throttle handle: revolve to the lowest place according to picture. (Normal situation is loose the throttle handle, and the engine is idling speed) Put the key to “（ ）” • 。 Fig20 Fig21 Stopping operation: When the motorcycle stop, put the key to “ ” position .put down stand and lock handle. • Alarm points: 1 Locking the handle and do not left key in the switch 2 Put the motor into the garage 3 Use the excellent guard against theft device - 17 - IV.
Cycle 1 Item ﹡ ﹡ ﹡ ﹡ ﹡ ﹡ Every month Fuel pipe I Operation of the throttle Core of the air filter I Tabel 3 speedometer（x1000km） 4 8 12 Ref page 6 12 18 I I I I I I 15 22 C/1000km, if need: R 25 Spark plug C/2000km,If need: R belt Per1000km I If need: R I 24 Gearbox oil Note （300km） I I I I 23 Idling speed I I I I 11 Brakes system I I I Brakes switch I I I Headlamp ﹡ I I I Suspension ﹡ I I Note ﹡ nuts\bolts tighten 2 I I I 13 Wheel & tire ﹡ I I Turning bearing ﹡ *If you have all of tool and maint
Chart 4 Complaint The vehicle is unable to accelerate performance badly Symptom and possible causes Change fuel Oil path stop up Clean oil path Ignition time is too early or too late Check coil and change CDI Spark too weak or flameout Check ignition and clear out Mixed air too dense or race Clean& adjust carburetor Engine leak Check and clear out Muffler stop up Dredge Belt wear Turning bearing gap too wide Replace Replace Replace Replace Charge Adjust Lack of tire pressure Pump Front&
If the motorcycle have not been used for a long time. Taking off the battery and putting it into a dry and place The head of battery was corroded, please take it off and clean. (Can use boil water) - first, but install positive NOTICE: turn off the ignition switch, take apart negative pole ○ + when you are installing.
Spark plug (Fig 27) The specification of spark plug: BPR7HS BP7HS（NGK）、E7TC OR E7RTC Take apart the spark plug; Take it of with special tool. Examine if there is dirty on poles and the porcelain head in center . If it has corroded, must change it .It is the best way to clean with 1 the liquor of spark plug Use wire brush if no cleaner. Normally the gap between side electrode (1) and Center electrode (2) is 2 0.6-0.7mm. Don’t use other spare plug.
6. Put the vehicle in a shady and cool place free from humidity and direct sunshine and cover it properly (but not with plastic or other painted materials). Reuse motorcycle. Clean the motorcycle, if the storage time beyond 4 months, Must change gasoline. Must charging if need, and then install battery. Must check all of terms before drive (Page 11), for the safety must try the motorcycle with lower speed for some time in a not busy rode. Ⅵ. Vehicle Identify Position of the model No, VIN No and engine No.
Ⅷ.Main technique parameter ITEM Table 5 ITEM Ground clearance (mm) SPECIFICATION 1870×700×1120 1300 125 Dry weight 106 Air pressure of Rr Tyre SPECIFICATION 120/70-12 120/70-12 150 kPa 200 kPa Max payload (kg) 150 Transmission system CVT Turning angle of steering handle ≤45 º Gear ratio 10.83-33.
IX Circuit diagram - 31 - Ⅹ.Emission Control System Warranty Statement Wangye USA Co., LLC is pleased to explain the emission control system warranty on Highway Motorcycle. New Highway Motorcycle must be designed, built and equipped to regulations and standards of the United States Environmental Protection Agency and the California Air Resource Board and free from defects in material and workmanship that may keep it from these requirements in the all applicable regulations. Wangye USA Co.
2. Responsibilities of Customer To obtain repairs under warranty, the customer must: (i). Ensure that the motorcycle is properly operated, maintained and stored as specified in the Owner’s Manual; (ii). Give notice to dealer approved by Wangye USA Co., LLC or other qualified service facility of any and all apparent defects immediately upon discovery, and make the entire motorcycle available at the time for inspection and repair at the dealer’s place of business; (iii).
- 35 -
