Operation Manual
21
GB
Setting the desired temperature
Press and hold the AUTO button until the TEMP indication blinks. You can set a higher temperature with the
button and a lower temperature with the button. Then wait a few seconds, or press the AUTO button to
switch to the automatic modus.
Checking the set temperature
Briey press the AUTO button. The display briey shows the pre-set temperature and then displays the room
temperature.
TIMER
You can pre-set a total of four time-settings. When you link up all four time-settings, you can be sure of a
comfortable room temperature at all times.
Press and hold the TIMER button until the indication P1<> blinks. With the and buttons you can set
respectively the hours and the minutes. By briey pressing the TIMER button you can browse through the
timer programme P1<>, P1<>, P2<> and P2<>. Here is an example of a possible pre-setting.
P1<>-temp: 07:30 - 08:30 the pre-set temperature
P1<>-temp: 08:30 - 17:00 o
P2<>-temp: 17:00 - 23:00 the pre-set temperature
P2<>-temp: 23:00 - 07:30 o
The TIMER function works only when the pilot ame is on. If the TIMER mode is switched on, the temperature
control will be the same as in the AUTO position. You can switch o the TIMER mode with the and
buttons. The remote control will automatically switch to the MAN function.
MAN
When the display shows the MAN position you can manually turn the hearth higher and lower by using
the big buttons. When you press and hold the button the hearth will go to its lowest position: the pilot ame.
When you keep these buttons pressed, you will see the ‘transmit’ symbol top left in the display. You will know
when the hearth has reached its highest or lowest position when the LED of the receiver starts blinking.
Maintenance
Small maintenance
You can clean the outside of the hearth with a damp cloth that doesn’t give o u. Only clean the outside
when the hearth is cold. If some coee is spilled on the unit when it is burning, turn the hearth o immediately.
When the hearth has cooled o completely, you can remove any stains with a damp cloth
Do not use any aggressive cleansing agents or abrasives and do not use stove polish.
Annual maintenance
Your gas hearth needs to be checked and maintained by a certied installer at least once a year. He will check
and, if necessary, clean the following components:
• The air-tightness of the exhaust pipes for gas and fumes and the pipes for supplying combustion air.
• The proper functioning of the gas governor, the thermocouple interrupter (a safety measure against un-
expected outow of gas) and the ignition of the main burner.
• The entire pipe system, including the exterior wall or roof duct and the external terminal.
• Inspection of possible wear and tear of the sealing of the doors and glass panes.
• The following components will be cleaned: the main burner, the pilot light, the ue tube and the supply of
combustion air. Any dust collected in the hearth can be removed with a vacuum cleaner.
!