Operating Instructions and Installation Instructions

19

The appliance must stand on a
non-combustible constructional
hearth which is at least 125mm
thick with the minimum
dimensions as shown in
diagram. If it is to be fitted in a
raised setting consideration
may need to be given to
extending the depth of the
hearth to safely containing any
falling logs or embers.
The building must have a
suitable load-bearing capacity
for the hearth and appliance.
Consult a structural engineer
for advice before proceeding
When fitting into an existing hearth check:
That the appliance complies with current construction regulations and is at least the minimum sizes
shown
If there is no existing fireplace or chimney it is possible to construct a suitable non-combustible
housing and hearth setting. The flue must be installed in accordance with all local and national
regulations and current rules in force .
Check if adding a new chimney to your property requires planning permission
Some houses are built using a timber frame construction with high levels of thermal insulation. Isolate
the appliance from combustible materials, and provide sufficient ventilation to maintain the heating
efficiency.