Operation Manual

2.9.5 Using various options

Manual adjustment of the height of the ames.

Press ()toswitchonthereortoincreasetheheightoftheames;press()todecreasetheames

ortoswitchtothepilotameofthestove.

When pressing these buttons, the ‘send’ sign will appear in the upper left corner of the display. When

the gas valve has reached its maximum position, the LED of the receiver will start blinking to indicate

that the highest or lowest position is reached.

AUTO temperature adjustment

Press AUTObrieyandthedisplaywillindicatetheprogrammedtemperaturetobefollowedbythe

temperature in the room.

2.9.6 Timer (TIMER)

If the timer mode is switched on, the temperature control is the same as in the AUTO mode. When the

switch-offtimesarereached,themotorswitchestheappliancetothepilotame.

Press AUTO to check the temperature settings and return to the TIMER mode.

There is no temperature control when the time is switched off; this will minimize battery consumption.

By pressing the () or the () button, you will reach manual operation from any mode.

We recommend that you switch off with the () button, as the transmitter will then be inactive and will

not use the battery unnecessarily.

2.9.7 Changing the battery

The battery needs to be changed when BATT appears in the top right corner of the display, or when the

LED light on the receiver becomes less bright.

2.9.8 Safety switch-off

If the receiver has not received any signal for two hours, the unit will switch automatically to the pilot

amemodeandwillswitchonagainassoonasasignalisreceived.

2.9.9 Directions

Before switching to AUTO or TIMER you must test reception with the () and () buttons (when the

‘send’symbolappearsonthetransmitter,theLEDonthereceiverwillash).

Withthetemperatureadjustment,theheightoftheamesisprogrammedduringthetimethatthemotor

is running. The time depends on the size of the room where the unit is placed, on the capacity of the

unit, on the power of the battery, and so on.

A microprocessor measures the increase in temperature per time, and adjusts the running time of the

motorduringthenextheatingperiodtoadjusttheheightoftheamestoyourneeds.

If the room can be heated in a lower position, the hearth will burn in a lower position or turns off

when the hearth is burning on the automatic position. This gives longer burning times and a regular

temperature.

Required batteries: 1x 9V alkaline for the remote control and 4x AA 1.5V penlight receiver