Operation Manual

24
8. The wall behind the stove must consist of, or be insulated with,  re-proof materials. The insulation material
must resist a temperature of 700 °C and have a density of 80 kg/m3. Please see for insulation materials
table page 27).
9. Avoid heat transmission when placing the stove. Heat transmission of a burning stove can penetrate the
wall and even cause  re damage on the other side of the wall. Prevention is better than cure.
Installation
The Square Basic is tested in accordance with the international EN 13229 standardization, and has an extra
additional standardization for optimally environment-friendly heating devices related to  ue gases (Section
15a B-Vg. Des BmfWA). The stove can be connected to a  ue tube to which several stoves are connected. The
 ue tube has a diameter of 150 mm.
Supply of combustion air
The stove must have enough supply of fresh combustion air. If necessary, make an extra air supply opening as
close to the stove as possible to avoid draught. An extra opening for air supply is always required if:
• the space has a heat recovery system.
• the space has a central exhaust system.
• there is a cooker hood in the same space.
The air supply opening must be closable if it goes through a  re-resistant wall. When there are several
combustion devices in the same space there must be enough air openings to guarantee proper combustion.
Connecting the stove
The Square Basic is a heavy insert. Check whether the  oor on which the stove is placed can carry this weight
without problem.
You must follow the directions given in de previous chapter on ‘Preparation” before installing. Please mind
your back and the  oor during installation!
1. Check the packing. If you detect any visible damage, please notify the supplier.
2. Take the stove from the box.
3. Remove the  ue collar from the stove by unscrewing the 4 bolts.
4. Place the insert at it’s  nal position. Make sure that it is positioned right beneath the chimney.
5. Connect the  ue collar to the  ue system with the upper sections  tting into the lower sections.
6. Place the ba e plate into the stove.
7. Your stove is ready for use.
4 x M6