Operating Instructions and Installation Instructions

20
failed. Possible cause: air in the pilot burner pipe.
Important: If the pilot ame has gone out you must wait at least 5 MINUTES before repeating the
above-mentioned steps.
Setting the height of the ames
• After igniting the burner, the height of the ames will automatically reach the maximum position.
• Press button  continuously to lower the ames and to switch o the burner (putting the re out: “STAND
BY”). Press button  briey to gradually lower the ames.
• Press button  to increase the ame height. Briey press button  to gradually increase the ames.
Switching o the appliance
• Press button  to lower the ames and to switch o the burner.
• Then press “OFF” button  to switch o the entire unit, including the pilot ame.
• If the appliance is not used for a longer period it is advisable that you turn o the gas valve in the gas pipe.
Important: if the pilot ame has gone out for whatever reason, you must wait at least 5 MINUTES
before lighting the pilot ame again.
Failure
If it looks as if the signals of the remote control are not properly received by the stove (receiver), it may be
caused by:
• Empty batteries: change the batteries.
• An electronic problem: solve it by pressing the “RESET” button on the receiver.
• If the appliance often switches o you should contact your installer.
Control (manual control)
If the batteries are due for replacement or if the receiver is defect, you can also operate the hearth by hand.
To do so, you need to disconnect the ignition (piezo) cable of the receiver and slide it gently onto the piezo
connection of the gas control block.
Lighting the re and putting it out
1. Open the gas stopcock which is mounted in the gas pipe leading to
the appliance.
2. Press “O I” switch  on the gas control block in the “I” position.
3. Turn motor switch  on the gas control block all the way to the right.
The switch will make a ticking sound.
4. Turn operating switch  on the gas control block in the MAN
position; an orice  becomes visible.
5. Push the metal pin in the orice with something like a small pen. The
gas will now ow to the pilot.
6. While keeping the metal pin pressed in, press the (square) ignition
fuse  (next to the “O I” switch) to ignite the pilot ame. Look through
the glass to see whether the pilot ame is burning.
7. If the pilot ame is burning, keep the metal pin pressed for another
10 seconds and then release it. If the pilot ame dies, wait for another
5 minutes before repeating the above steps.
8. Turn operation knob  to the “ON” position.
9. Turn motor switch  to the left to ignite the burner and to select the
height of the ames.
!





!