Operating Instructions and Installation Instructions

19
GB
Setting the time
• Press the big-ame button  and the small-ame button  simultaneously, and the display will show short
ashes to indicate that you are in the set mode.
• When in the set mode, press the big-ame button  to set the hours, and press the small-ame button 
to set the minutes.
• Wait or press the OFF button  to return to manual control.
Switching from ºC/24-hour to ºF/12-hour indication
• Press the OFF button  and the small ame button  simultaneously (2 sec) to switch from ºF (and the 12-
hour indication) to the ºC (and the 24-hour indication), and vice versa.
Possible settings
• By pressing the SET button  you can switch quickly between MAN  day temperature  lamp  ventilator
 night temperature  timer  MAN.
• MAN: this setting allows you to turn the ames manually higher or lower with the big-ame button  or the
small-ame button .
• Day temperature (): this mode allows you to set the desired daytime temperature; the remote control set
will function as a thermostat.
• Night temperature (): this mode allows you to set the desired night temperature.
• TIMER: this mode allows you to preset 2 switch-on and 2 switch-o times per 24 hours. If the night setting is
on - - -, the stove will burn on the pilot ame.
Setting the temperature
• Select the day temperature or night temperature by briey pressing SET button .
• Now press SET button  longer until the display starts ashing.
• Preset the temperature with buttons  or  (5 ºC is the minimum day temperature).
• Wait or press OFF button  to switch back to the thermostat-controlled system.
• In order to save the batteries you are advised to reset the night-temperature until the display shows the ‘- - -‘
signal.
Setting the timer function
• Select the timer function by briey pressing SET button  a few times.
• Now press the SET button  longer until P1 () starts ashing.
• Set the hours with button  and the minutes with button .
• Briey press SET button  for the next timing.
• Once all 4 timings have been set, press OFF button  to end the presetting.
Operation (remote control)
Igniting the re
• Open the gas turncock that is xed in the gas pipe leading to the stove.
• Press “O I” switch  on the gas control block in the “I” position.
• Turn control button  on the gas control block to the ON position.
• Simultaneously press buttons  and  on the handset. A short acoustic
signal indicates the start, and is followed by short acoustic signals (0.2
sec/signal, 1Hz.) until the pilot ame and the chief burner are ignited.
After the main burner has lit, the ame height will automatically go to
the maximum position.
Possible error messages
• Long signals (0.8 sec. signal with 0.2 sec. interval) during lighting : batteries of the receiver are almost
empty. (After hearing this signal, you can switch on the appliance for about another 10 times.)
• 5 seconds continuous signal : error message. One of the cables may not be connected, or the “O I” switch
is not in the “I” position.
• 5 short signals (0.2 sec. signal with 0.2 sec. interval) : ignition of the pilot ame and the main burner has

