Instructions / Assembly

WWW.WAMBAMFENCE.COM
7
ASSEMBLY INSTRUCTIONS
BL19103
STEP 2: INSTALL PIPE ANCHORS AND POSTS
Note: Try and drive the pipe anchor as level as possible. Check level
about every 12”. Aer about 18” the trajectory of the pipe anchor is
usually established, and you cannot manually pull it level (donut will
not compensate for a severely crooked pipe).
Note: Remove the top donut and
slide it up over the pipe. Your
post pounder barrel cannot be
longer than 24”.
BEST
BETTER
GOOD DO NOT USE
G
 

(G)


pipe anchor and drive it into the ground.
If you removed the upper donut,
slide it back down over the inner
gear.
Post Pounder
10lb Sledgehammer
5lb Sledgehammer Hammer
STEP 2.2
STEP 2.3
Note: Distance between inner
plasc gears (not donuts) to pipe
should be 70⅜” (or center to cen-
ter of pipe at 72”).
72”
STEP 2.1
70⅜”
String line