Instructions / Assembly

WWW.WAMBAMFENCE.COM
3
ASSEMBLY INSTRUCTIONS
BL19103
TIPS
1.
2.
inside gear to the next pipe anchor.
3.
remove the posts to create an unobstructed string line.
4.
5. Once the pipe anchors are set, you can use your string line to adjust your lower donuts to make a
straight fence line (Figure A). Then use a level to adjust the top donuts to ensure each post is level to
(Figure B).
6. 
pitched or is very uneven, you may need to stair step your panels as illustrated below. Post heights
can be trimmed down as necessary.
Figure A
(View From Top)
Pipe Anchor String Line

Donut

Wood Spacer
Adjust top
donut to level
Figure B
(View From Front)
Note: The boom of the rail bracket
on the higher side of the fence
should sit ush to the top of the
ground.
WARNING!


long enough to accommodate this slope.