Instructions / Assembly

WWW.WAMBAMFENCE.COM
7
ASSEMBLY INSTRUCTIONS
BL19101
STEP 2: INSTALL PIPE ANCHORS AND POSTS
Note: Try to drive the pipe anchor as level as possible. Check level
about every 12”. Aer about 18” the trajectory of the pipe anchor is
usually established and you cannot manually pull it level (donut will
not compensate for a severely crooked pipe).
Note: If you are using a post
pounder, remove the top donut
and slide it up over the pipe. Your
post pounder barrel cannot be
longer than 24”.
BEST
BETTER
GOOD DO NOT USE
F
 

(F)


pipe anchor and drive it into the ground.
If you removed the upper donut,
slide it back down over the inner
gear.
Post Pounder
10lb Sledgehammer
5lb Sledgehammer Hammer
STEP 2.2
STEP 2.3
Note: The distance between the
inner plasc gears (not donuts) to
the pipe should be 70⅜” (or center
to center of pipe at 72”).
72”
STEP 2.1
70⅜”
String line