Instruction Manual

SSP-E
\\Client\S$\tb\BED-WERB\SSP\2788241_Anleitung SSP-E-Stand_Jan2015.docx
ond long flash. Take your finger off the trigger, hold the pistol with muzzle pointed up and barrel ver-
tical, suspend a 1000g trigger test weight on the trigger, and push the button switch “e” in front of
the diode. For pushing use a allen wrench size 2, a toothpick or any other tool. The diode will flash a
few times to confirm the adjustment and the trigger will be released automatically. After this please
check trigger pull force. If required, final adjustment of trigger pull force can be done by adjusting the
take up force.
Take Up Travel:
Turning screw „c“ clockwise will increase take up travel, and will reduce it when turned counter-
clockwise.
For two stage trigger mode: Unscrew screw „c“ until trigger stops to work, then screw „c“ back in
just a little.
Trigger Stop:
The trigger break on your SSP-E pistol is done by a pressure sensor without any physical movement at
the trigger’s break point. This is the reason why the SSP-E trigger does not have any overtravel after
releasing and why the pistol is not equipped with a trigger stop adjustment screw.
Trigger Break Point:
Where the trigger breaks can be adjusted by turning screw “a”. Changing the setting is generally not
required.
4. Handling / Shooting / Safety instructions!
Please always hold the pistol in such a way that no body is in danger. Even an unloaded weapon had
to be handled as though it is loaded. Train to familiarize yourself with this important aspect of han-
dling with the unloaded weapon until you master every step perfectly. Read the instructions through
carefully to the end before firing the pistol.
Before starting to shoot the electronic device of the pistol has to be switched on:
 Push back the slide using the cocking grips and fix it in the rear position using the slide stop
 Make sure that there is no cartridge or loaded magazine in the weapon.
 Pull back and hold the finger rest until the LED begins to blink.
 Insert the loaded magazine into the pistol and close the slide.
 Unlock the pistol by swivelling the safety catch to position „F“
 The Pistol is now ready for shooting.