Owner's Manual
-4-
-5-
3. LOADING THE GUN
3.1 Removing the magazine:
To remove the magazine, press the magazine holder down and remove the magazine.
3.2 Charging gas:
Shake the blowback gas container well before you use it.
!
CAUTION:
You should make it a habit to leave the safety always in
the "safe" position until you really intend to fire.
!
CAUTION:
Gas is flammable! Do not smoke!
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
muzzle
foresight
barrel
extractor
safety lever
F (safety on fire)
handle plate screw
hook for catching strap
slide catch
trigger guard
trigger
handle
dismounting lever
hammer (cocked)
loading index
rearsight
trigger sear
handle plate
magazine holder
gas charging hole
magazine base
magazine follower
loading port
seal
tapped rod
2
1
3
4
5
14
15
16
12
11
10
9
13
17
18
8
7
6
19
22
23
24
25
20
21
2. OPERATION OF THE SAFTEY
• The safety is on safe when the safety lever is in a position that the "S" is visible
above it. The trigger is blocked and the gun cannot be fired.
• To put the safety on fire, push the safety lever up so that the "S" is covered and
the "F" is visible. (see illustration)
Note: If the hammer is cocked after firing it will be decocked as soon as the
safety is put on "safe". If a BB is left in the barrel, it can now be ejected.
2265001_P38_man_V6_4.07.indd 4 02.05.2007 09:09:05
-4-
-5-
3.4 Inserting the magazine
Push the magazine into the gun until the magazine holder locks.
4. PROPER AIMING AND FIRING
Before you fire the first shot: Put the safety on "fire". Retract the slide until you feel
that it locks. Let the slide go. Now a BB has been loaded into the barrel and the striker
has been cocked.
Note: If you fire the gun without having cycled the action first there will be no
discharge of a projectile. Only the pressure required for shooting will be built up
and the BB will be loaded.
Aim at a safe target. Hold the gun in a way that you see rear sight and foresight in one line. The foresight must be right in
the center of the rear sight notch. Now you lift the gun until the lower edge of the bull's eye of the target is on the upper
edge of the foresight. Upper edge rear sight - upper edge foresight -
lower edge target must all be in one line.
wrong: right:
In case the rear sight is out of adjustment, adjust it as follows:
point of impact too far right - turn adjustment screw clockwise
point of impact too far left - turn adjustment screw anti-clockwise
Firing:
1. check safety (must be on "fire")
2. pull trigger
3. the striker will be released and the BB will be fired
4. the slide moves backwards and then forward again and cocks the hammer.
Note: With the gas tank empty, the hammer will move backwards,
the slide remains in its position and will not cock the hammer again.
Keep the magazine in the illustrated position, with the gas charging hole at
the top. Keep the gas container vertical and press the charging tube into the
gas charging hole. As soon as the tank in the magazine is full there will be a
discharge of gas.
3.3 LOADING THE MAGAZINE
Pull the follower down and load it with up to 12 BBs as illustrated.
Note: Warranty expires if non-recommended BBs are used. It‘s recommended to use precise BBs
from UMAREX-USA/Walther.
!
WARNING:
Use .24 caliber (6 mm) plastic BBs only in this soft air pistol. Use of any other ammunition can
cause injury to you or damage to the soft air pistol.
diameter larger than 6 mm
with edgesoffset halves
used, soiled
!
CAUTION:
Make sure that the muzzle of the gun always points
into a safe direction. Never aim at animals or persons.
Always treat your gun as if it was loaded and ready
to fire.
muzzle
foresight
barrel
extractor
safety lever
F (safety on fire)
handle plate screw
hook for catching strap
slide catch
trigger guard
trigger
handle
dismounting lever
hammer (cocked)
loading index
rearsight
trigger sear
handle plate
magazine holder
gas charging hole
magazine base
magazine follower
loading port
seal
tapped rod
2265001_P38_man_V6_4.07.indd 5 02.05.2007 09:09:12