Owner's Manual

4.2 Unloading the pistol
Put air pistol "On Safe" (See Step 2.1).
Open the slide (See Step 4.1).
Remove the pellet clip and close the slide. Using a ramrod,
gently push each pellet out of the pellet chamber.
IMPORTANT: Never use sharp metal tools to remove pellets.
Replace the empty pellet clip (ratchet teeth facing the rear sight)
in the pistol (See Fig. 10).
Close the slide by pushing it all the way back until it locks into
place (See Step 4.1 and Fig. 11).
Check to make sure the barrel is completely unloaded by
pointing the muzzle in a SAFE DIRECTION, taking "OFF SAFE"
(See Step 2.2) and pulling the trigger to fire. You may also
unload your air pistol by following the directions listed under
Step 8 - Removing a jammed pellet.
Fig. 11
Make sure that the air pistol always points in a safe direction. Never point at peo-
ple or animals. Always handle the air pistol as if it was loaded and ready to fire.
WARNING:
Due to high shooting velocity of this airgun, take particular care and caution in
choosing a safe target. Only choose targets with a safe backstop. Do not choose targets that will cause
ricochets. Never shoot at water.
WARNING: