Operation Instructions

- 2 -
2. Mounting
Loosen the locking screws at the mounting base and slide
the sight with the mounting base onto the Weaver-rail. The
reflex lens of the sight is to point towards the shooting direc
-
tion of the gun.Tighten the locking screws.
Note: A minimum distance of 3 inches (7.5 cm) is to be kept
between eye and sight when the gun is fired.
3. Operation and adjustment
The combined on-/off switch and the brightness regulator
for the electronic Walther Multi Reticle Sight MRS is situated
on the top side of the sight. With the switch set to a position
between 1 and 7, a red dot of different brightness is pro
-
jected onto the lens. To aim, simply align the red dot with
the intended target. Positions of the switch: pos. 0 = red
dot off, pos. 1 = minimum brightness to pos. 7 = maximum
brightness.
The reticle regulator can be used to select 4 different types
of reticle depending on the shooting situation.
Attention: Do not forget to switch the red dot off after use of
the Multi Reticle Sight.
3.1 Battery
Your MRS red dot sight is powered by a 3V lithium battery
(CR 2032 or similar types). The battery should be changed
when the red dot gets slowly darker or disappears altogether.
To insert a new battery, unscrew the battery compartment
lid with a coin while you hold the lower part of the rotating
numbered knob. After the battery has been inserted with the
positive (+) pole upwards (as illustrated), replace the battery
compartment lid.
battery compartment lid
Battery
on-/off switch and
brightness regulator
shooting direction
reticle
regulator
on-/off switch
and brightness
regulator
locking
screws
1
2
3
4
2300569_MRS_man_02.03.indd 2 09.03.2007 08:43:23