Operating Instructions

35
LP500 MATCH AIR PISTOL
DE
EN
ES
FR
1 Compensator setscrews 4 Frame
2 Compensator 5 Positioning pin
3 Barrel jacket 6 Slot
• Loosen the setscrews (1) on the compensator (2) with a 2 mm Allen key.
• Pull the compensator forward.
• Pull the barrel jacket (3) from the barrel.
• Press the new barrel jacket onto the barrel up to a stop in the frame (4).
• Make sure that the positioning pin (5) sits in the slot (6) on the barrel jacket.
• Press on the compensator and tighten the setscrews.
• Shoot at a test target. It may be necessary to correct the elevation and windage.
6.7 Modification of weight
The balance and the total weight of the pistol can be adjusted by attaching weights to the
barrel jacket and weight bar.
6.7.1 On barrel jackets
6.7.1.1 Rectangular barrel jacket
• Screw off the compressed air cylinder.
• Insert a weight (1) via the opening (2) into the rail on the bottom of the barrel jacket and slide it
forward.
• Tighten the setscrew (3) to fix the weight in the desired position.
1 Weight
2 Opening on barrel jacket
3 Setscrew
2
1
3
Figure 24