Operating Instructions

30
LP500 MATCH AIR PISTOL
6.5.2.2 Rotating the trigger blade and moving it forward and back
• Loosen the screw (2) using the 2 mm Allen key.
• Move the trigger blade forward or back or rotate it to the desired position.
• Retighten the screw (2).
6.5.3 Adjusting the position of the trigger carrier
The trigger carrier (5) can be moved forward or back and turned to the left or right.
• Loosen the setscrews (6) with a 1.5 mm Allen key.
• Push the trigger carrier on the horizontal pin to the desired position.
• Turn the trigger carrier to the right or left if needed.
• Retighten the setscrews.
• Adjust the trigger blade (see Section 5.5.1).
6.5.4 Changing the first-stage trigger travel
The slack between the resting position of the trigger blade and the let-off point can be regulated by
turning the adjusting screw (7) with a 2 mm Allen key.
• Shorten the first-stage trigger travel: Turn the adjusting screw clockwise.
• Lengthen the first-stage trigger travel: Turn the adjusting screw counterclockwise.
6.5.5 Adjusting the trigger pull weight
The trigger pull weight is the sum of the first-stage trigger weight and the second-stage trigger
weight. In order to increase the trigger pull weight, the first-stage trigger weight and/or the se-
cond-stage trigger weight can be increased.
NOTE
The trigger blade can be turned in steps or continuously. In delivery condition the
pistol offers a choice between two steps. To enable continuous adjustment, rotate the
trigger blade by 180°. This can be done only when the trigger unit has been removed
(Section 6.5.8).