Operating Instructions

23
LP500 MATCH AIR PISTOL
DE
EN
ES
FR
6.4 Adjusting the sight
Setting the sight and sight length depends on the anatomy of the shooter. The ideal positions of the
rear and front sights must be determined by testing and individually adjusting.
6.4.1 Rotating the sight
The sight can be rotated about the barrel axis. It is supplied in a zeroed position and can be rotated
by 10 degrees in either direction depending on the shooter’s requirements.
• Loosen the fastening screws (1) on the rear sight using the 2 mm Allen key
• Set the desired angle and retighten the fastening screws.
• Loosen the fastening screws (2) on the compensator using the 2 mm Allen key
• Adjust the angle of the front sight to that of the rear sight. To do this, place the pistol on a flat
surface with the grip pointing up.
• Retighten the fastening screw.
Check the settings using test targets. It may be necessary to correct the elevation and windage (see
Sections 6.4.3.2 / 6.4.3.3).
!
WARNING
Adjustment of the sight poses the risk of unintended firing.
Ensure that the pistol is unloaded and uncocked when making adjustments.
!
CAUTION
Unsuitable surfaces can damage the sights!
1 Fastening screws for rear sight
2 Fastening screws for compensator
1
1
2
Figure 10 Figure 11