Operating Instructions

20
LP500 MATCH AIR PISTOL
6.2.2 Adjusting the hand rest
The hand rest can be continuously adjusted to adapt to your hand width.
To do this
• Loosen the fastening screws (4) with the 4 mm Allen key.
• Move the hand rest (3) to match the width of your hand.
• Tighten the fastening screws.
Check the settings using test targets. Repeat the adjustment process until the necessary stability
settings are achieved.
6.2.3 Changing the volume
• Before starting, make sure to loosen the clamping screw (5) with a 2.5 mm Allen key.
• The contoured grip plate (6) is supported by three setscrews (7). These can be turned in by any
amount using a 2.5 mm Allen key to determine the distance of the plate to the main grip.
• The contoured grip plate can be set parallel to the grip or at an angle (both horizontally and
vertically).
• Once you have found the optimum setting, secure it by retightening the clamping screw (5).
NOTE
It is best to make this adjustment while holding the grip in your hand.
The grip volume should be set so that the middle joint of the middle finger is roughly
at a right angle to the barrel axis.