Operating Instructions
14
LP500 MATCH AIR PISTOL
5.2.1 Inspecting the load status using the safety line
Hold the pistol firmly in your hand, finger away from the trigger.
• Open the loading tray (5, Fig. 1) by pulling back the loading gate until it engages at the rear end
position.
• To inspect, shove the safety line into the barrel opening all the way to the loading tray until you
see a pellet or the safety line.
• Remove the pellet or safety line.
• Ensure that there are no foreign objects in the barrel.
• Close the loading gate.
The safety inspection is thus complete.
5.3 Shooting
Check the pressure in the compressed air cylinder with the built-in pressure gauge, fill if necessary
(see Section 6.2) and conduct a safety inspection before shooting.
5.3.1 Cocking and loading the pistol
• Checking the dry-firing setting
• Pull back the loading gate (1) until it engages at the rear end position.
• Insert a pellet (diabolo, caliber 4.5 mm) with the smooth surface forward into the open loading
tray (2).
• Close the loading gate.
The pistol is cocked, loaded and ready to fire.
!
WARNING
Firing the pistol can result in severe injury to the user and persons in the
vicinity.
Observe the safety instructions for handling weapons (Section 2.2.2)
Only fire in a safe direction.