Instruction Manual

LP400 – Operating Instructions
-31-
Setting the rear sight
Set the position of the rear sight in such a way that the sight leaves are directly
over your wrist. To reposition the rear sight, loosen the screw (a). After setting
the position, retighten the screw (a).
Guideline for elevation and windage correction: When the sight length is set to a
maximum, the impact point will be moved by 1 mm per click at a firing distance
of 10 m.
Elevation correction using adjusting screw (b)
If shots group high, turn the screw in the direction of the arrow (clockwise).
Windage correction using screw (c)
If shots group to the right, turn the screw in the direction of the arrow (clock-
wise).
Rear sight width correction with screw (e)
Turn the screw in the direction of the arrow (clockwise) to increase the width of
the notch.
Rear sight depth correction with screw (d)
Turn the screw in the direction of the arrow (clockwise) to increase the depth of
the notch.