Instruction Manual

7
end of the stock when the monotec block is moved. The receiver can also be raised by 6.5 mm. For
this purpose spacers and matching screws, both available as accessories, must be placed between
the monotec block and the stock.
It may then also be necessary to change
the height of the finger position.
2.8 SIGHTING IN WHEN THE STOCK IS CLAMPED
One advantage of the monotec block is that the receiver or the entire rifle can be clamped on the
monotec block for sighting in on a shooting range. For this, the monotec block must be clamped in
the area below the edge. To avoid damaging the block, apply as little clamping force as possible.
b
DE
EN
ES
FR
2838699 rev b BA LG400 monotec EN.indd 7 06.06.19 18:23