Instruction Manual

55
2.3 ADJUSTING THE BUTT PLATE AND STOCK LENGTH
To alter the stock length, undo the clamping screw
(a), after which the stock length can be varied by
turning the setting wheel (b). Then retighten the
clamping screw (a).
If the stock length cannot be extended far enough,
a longer stock can be obtained by using longer rods
(special accessory).
To alter the cheek piece inclination, undo the
clamping screws (c). It may first be necessary to
undo the clamping screw (a) and to turn the setting
wheel (b) towards the butt plate so that the rods can
move freely.
It is also possible to move the butt plate to the side or to angle it. If the butt plate has to be moved,
undo the fastening screws (d). Once the required position has been obtained, retighten the fastening
screws.
2.4 DISPLACEMENT OF THE BUTT STOCK
Open the four clamping screws (a) to move the butt stock up or down.
a
a
c
a
b
d
c
c
c
d
DE
EN
ES
FR
2838699 rev b BA LG400 monotec EN.indd 5 06.06.19 18:23