Instruction Manual

2.1 GRIP

The grip is fastened to a ball-and-socket joint,

allowing every possible movement about this center

point. In addition, the position of the grip can be

moved in the longitudinal direction, sideways and in

its height. For longitudinal adjustment and lateral

displacement, undo screw (a) and move the grip to

the required longitudinal and lateral position. Then fix

this setting using the screw (a).

Change the height of the grip by undoing the clamp-

ing screw (b). Ensure here that the screw (b) is flush

with the flat surface of the grip.

Set the three-dimensional inclination and rotation out of the middle plane of the grip using the

ball-and-socket joint which is fixed by the screw (c). To alter its setting, undo the screw (c), set the

required position of the grip and lock it in this position using the screw (c).

2.2 CHEEK PIECE

The cheek piece has a wide variety of possible adjustments. To adjust the cheek piece height ,

undo the clamping screw (a), then alter the height of the cheek piece using the setting wheel (b).

Use the countersunk screws (c) to adjust the lateral displacement of the cheek piece. When they

are undone, the cheek piece can be pushed towards or away from the face.

To change the surface of the cheek piece from angu-

lar to rounded, undo the countersunk screws (d)

and turn the cheek piece around. Then retighten the

countersunk screws (d).

To reposition the cheek piece forwards or rearwards

in the longitudinal direction, remove the counter-

sunk screws (d) and move the sliding blocks in the

required direction.

LG400 MONOTEC AIR RIFLE

2838699 rev b BA LG400 monotec EN.indd 4 06.06.19 18:23