Instruction Manual
2
PLEASE REFER TO THE LG400 OWNER'S MANUAL FOR ADDITIONAL INFORMATION.
Dear Sport Shooter,
Thank you for choosing one of our products. This premium stock combines cutting-edge technical
innovations with the latest findings from professional target shooting. We are confident that you
have selected an extremely high-quality product that sets the standard for quality and development.
Enjoy your new monotec stock / LG400 monotec air rifle and “aim true”.
The stock can be used with all LG400 and LG300 systems.
Your team at Carl Walther
1 MOUNTING / REMOVING THE STOCK
To insert the receiver into the stock, per-
form the following steps:
1. Make sure that there is no projectile in
the barrel.
2. Remove the compressed air cylinder.
3. Place the stock upright in front of you.
4. Open the four screws (a) in the two
clamps (b) of the block on the stock and
remove them.
5. Place the receiver with the barrel jacket
in the block.
6. Put the two clamps (b) in position on the
barrel jacket and insert the screws without tightening them.
7. Position the receiver in such a way that it is open at the side and that the back of the housing
makes light contact with the foam damper of the stock.
8. Evenly tighten the screws (a) in the clamping block. The tightening torque should not exceed
2Nm.
Caution:
Before performing any adjustment, assembly, maintenance or cleaning, always
make sure that the rifle is decocked and that the barrel is free of projectiles and
obstructions.
!
GEFAHR
LG400 MONOTEC AIR RIFLE
a
a
a
b
b
a
2838699 rev b BA LG400 monotec EN.indd 2 06.06.19 18:23