Instruction manual

Instructions for Use
- 17 -
5. Adjusting the cheek piece
The cheek piece has a wide variety of possible adjustments, most of which can
be made in the shooting position. To adjust the cheek piece height, undo the
clamping screw (a), then alter the height of the cheek piece using the setting
wheel (b).
The lateral displacement of the cheek piece can also be performed conven-
iently in the shooting position using the clamping screw (d). When the latter is
undone, the cheek piece can be pushed towards or away from the face. After
adjustment, retighten the clamping screw (d).
The cheek piece inclination can be altered by undoing the clamping screws (c)
and by rotation about the longitudinal axis, followed by retightening of the
clamping screws (c).
To reposition the cheek piece forwards or rearwards in the longitudinal direc-
tion, remove the countersunk screws (e) and move the sliding blocks in the
required direction. The best way to do this is to remove the complete cheek
piece from the stock (undo screw (a) and remove cheek piece) and the top
part of the cheek piece (undo screw (d) and pull off cheek piece to the side).
Another option for longitudinal adjustment is move the guide rods; to do so,
remove the countersunk screws (f) and reposition the rail. It is recommended