Instruction manual

Instructions for Use
- 16 -
4. Adjusting the butt plate and stock length
To alter the stock length,
undo the clamping screw
(a), after which the stock
length can be varied by
turning the setting wheel
(b). The retighten the
setting wheel (b) using
the clamping screw (a). If
the stock length cannot
be extended far enough,
a longer stock can be
obtained by using longer
rods (special accessory).
The butt plate inclination
can be altered by undoing
the clamping screws (c). It
may be necessary to undo the clamping screw (a) before adjustment and to
turn the setting wheel (b) in the direction of the butt plate to allow the rods to
move freely.
It is also possible to move the butt plate to the side or to angle it. In this con-
nection, please comply with the sports rules. If the butt plate has to be moved,
undo the fastening screws (d) to do so. Once the required position has been
obtained, retighten the fastening screws (d).
• Shortest possible setting ranges for shooters/juniors more than
160cm tall
• Simple release and locking of stock length
• Knurled screw permits adjustment with millimeter accuracy
• Independent adjustment of butt plate and butt plate attachment
• Removal and fitting in a single operation