Instruction manual

LG300XT CARBONTEC

OPERATING INSTRUCTIONS - SUPPLEMENT

Fore-end adjustment

Loosen the screw (1) to turn the fore-end on the longitudinal axis. To adjust the height

and inclination of the fore-end, loosen the screws (2). Retighten them afterwards.

-6-

LG300XT CARBONTEC

OPERATING INSTRUCTIONS - SUPPLEMENT

Cheek piece adjustment

The cheek piece can be easily adjusted without dismantling. To change the height, loosen the

socket head cap screw (1) and set the cheek piece to the desired height using the knurled screw

(2). Then fix this

setting with the

socket head cap

screw (1). To

adjust the inclina-

tion, loosen the

socket head cap

screw (3) and

tighten it again

after the required

position has been

found. Change the

lateral position of

the cheek piece by

loosening the

screws (4). If a

larger lateral ad-

justment is re-

quired, remove the

screw (3) and

move the entire

cheek piece side-

ways. To change the longitudinal position of the cheek piece, remove the screws (4) all the

way, take off the cheek piece, move the sliding blocks and put the cheek piece back on.

-3-