Instruction Manual

KK500 SMALL-BORE RIFLE

5.3 Adjusting the butt plate and stock length

To alter the stock length, undo the clamping screw (a), after which the stock length can be varied

by turning the setting wheel (b). Then retighten the clamping screw (a). If the stock length cannot be

extended far enough, a longer stock can be obtained by using longer rods (special accessory).

The butt plate inclination can be altered by undoing the clamping screws (c). It may first be neces-

sary to undo the clamping screw (a) and to turn the setting wheel (b) towards the butt plate so that

the rods can move freely.

It is also possible to move the butt plate to the side or to angle it. If the butt plate has to be moved,

undo the fastening screws (d) to do so. Once the required position has been obtained, retighten the

fastening screws.

b a