Operating Instructions

-36-
Removing the barrel weight
As a rule, there is no need to take off the barrel weight. When you clean the
system, remove the barrel along with the weight. If you nevertheless want to
take off the barrel weight, remove the front sight screw (a) and lift off the front
sight. Then remove screw (b) and loosen screw (c) by turning it a few times. The
barrel weight can then be taken off. To attach the barrel weight, reverse the
steps. When doing so, make sure that the threaded pin (c) engages in the recess
at the bottom of the barrel. Use screws (d) to adjust the spring force of the ab-
sorber weights (factory set). To increase the spring force turn the screws clock-
wise, and to decrease it turn them anti-clockwise.