Operating Instructions
35
FP500 FREE PISTOL
cal. .22l.r.
DE
EN
FR
2.10 Adjusting the grip angle
The grip angle can be adjusted over a range
of10°:
Loosen the grip plate securing screws (42, on
the opposite side 43) by approx. 1 turn.
- Adjust the grip to the desired angle.
- Tighten the grip plate securing screws.
-Use an SW 2.5 Allen key, through the rear of
the grip plate, to turn the Allen screw (40) out,
until it is up to the surface of the grip plate.
This ensures that the angle of the grip remains
the same every time it is reassembled.
2.11 Dry training
During dry training, only the hair trigger must be cocked by means of the cocking lever (25).
The breech must not be cocked, otherwise the firing pin can suffer damage.
If this piece of advice is adhered to, the FP500 can be used for dry training as often as desired
without taking risks.
40
42 (43)
b. Windage (lateral) correctiona. Elevation correction
d. Notch depth correction c. Notch width correction