Instruction Manual

26 27
CREED
Elevation
Elevation adjustments are made by using front sights
of varying height. Steel Front Sights of varying height
are an accessory item.
If the shots group low, use a lower front sight. For high
grouping, use a higher one.
The front sights are numbered. The higher the num-
ber, the higher the front sight. Each stage results in a
correction of the impact by about 5 cm over a 25 m
distance from target.
To change the front sight, field-strip the pistol as
described in section 4.1. Remove the front sight screw
(5.3 Fig. 2) using a screwdriver and press the front
sight upwards and out.
Assembly is in reverse order (5.3 Fig. 2). Remember
to make sure the screw and the thread inside the steel
front sight are free of oil or grease. The thread of the
front sight screw should be secured using an indus-
trial adhesive (for example Loctite 648). To tighten the
front sight screw, apply a torque of 1 Nm.
5.3 Fig. 2
5 ADJUSTING THE PISTOL TO ITS USER