Instruction Manual

22 23

5.1 Magazine Release

CAUTION Make sure the handgun is unloaded before making any adjustments.

The magazine release is reversible. In case you wish to reverse it, a 1 mm drift and a small

screwdriver (2.5 mm) is needed to do so.

1. Keep the magazine release pressed. By doing so,

the magazine release moves out on the opposite

side, revealing a small cut out on the side of the

button. Press a 2.5 mm screwdriver into this slot

and slowly release the magazine release (5.1

Fig. 1). While holding the screw driver into position

insert a 1 mm drift into the hole on the opposite

side of the magazine release and firmly press the

drift into the hole and lift upwards on the screw

driver (5.1 Fig. 2, the individual parts are shown in

5.1 Fig. 3).

2. Remove the magazine release (5.1 Fig. 4) and the

compression spring from the opposite side.

5 ADJUSTING THE PISTOL TO ITS USER

5.1 Fig. 1

5.1 Fig. 2

5.1 Fig. 3

5.1 Fig. 4