Owner's Manual

ManualsBrandsWalther ManualsAirgun AccessoriesCP99 Compact Laser

CP99 Compact Laser Sight

OPERATION INSTRUCTIONS

CAUTION: Your airgun is not a toy. Treat it with the same

respect you would a rearm. Always read all operation

instructions found here and in your airgun’s owner’s manual.

If you do not have instructions or an owner’s manual, contact

Umarex USA or visit www.UmarexUSA.com.

LASER SIGHTS ARE NOT TOYS. LASERS

MUST BE USED UNDER THE SUPERVISION

OF AN ADULT. IMPROPER USE OR CARELESS USE MAY CAUSE

SERIOUS INJURY, ESPECIALLY TO THE EYES. AVOID DIRECT

EXPOSURE TO THE LASER BEAM. AVOID SHINING AT MIRRORS.

DO NOT AIM AT ANY PERSON OR ANIMAL’S EYES.

KEEP OUT OF REACH OF CHILDREN.

WARNING:

HOW TO MOUNT YOUR CP99 COMPACT

LASER SIGHT

CAUTION: In order to avoid injury, keep the laser off until

you are ready to aim and shoot. Make sure the laser is off when

you mount or remove the laser sight.

Mount the laser sight as shown

in the illustration (See Fig. A).

Mount with the laser beam

aperture to the front and push

carefully back onto mounting

rail, until the laser sight locks

in place.

HOW TO REMOVE YOUR CP99 COMPACT

LASER SIGHT

To remove the laser sight,

press the locking lever down

on both sides at the same

time and remove the sight

from the mounting rail

(See Fig. B).

HOW TO OPERATE YOUR LASER SIGHT

CAUTION: Make sure the air pistol is pointed in a

SAFE DIRECTION. Keep the laser off except when shooting.

Never look directly at the laser or point the laser at anything

you do not intend to shoot.

Turn the laser on and aim.

Switch in the upper position = OFF

Switch in the lower position = ON

Continued on reverse.

Fig. A

Fig. B

Locking lever

Switch

Fig. C

D A N G E R

LASER RADIATION–AVOID

DIRECT EYE EXPOSURE

LASER DIODE

Wavelength 635-655 nm

Output Power <5mW

CLASS IIIA

LASER

PRODUCT

Summary of content (2 pages)

PAGE 1
CP99 Compact Laser Sight OPERATION INSTRUCTIONS DANGER LASER RADIATION–AVOID DIRECT EYE EXPOSURE LASER DIODE CLASS IIIA Wavelength 635-655 nm LASER Output Power <5mW PRODUCT CAUTION: Your airgun is not a toy. Treat it with the same respect you would a firearm. Always read all operation instructions found here and in your airgun’s owner’s manual. If you do not have instructions or an owner’s manual, contact Umarex USA or visit www.UmarexUSA.com. WARNING: LASER SIGHTS ARE NOT TOYS.
PAGE 2
HOW TO AIM AND ADJUST YOUR LASER SIGHT Use the front and rear sight to aim the airgun. The laser dot should appear to sit on top of the front sight (See Fig. D). If this is not the case, make the following adjustments by using a hex key: Laser dot Rear sight blade Front sight Fig. D Windage adjustment If your airgun shoots too far right, turn the windage adjustment screw counter-clockwise. If your airgun shoots too far left, turn the windage adjustment screw clockwise (See Fig. E).