Instruction Manual

10
fig. 21
fig. 19
10.5 Setting of the bolt speed
The bolt speed can be adjusted for different ammunition requirements. To reach the screw for bolt speed
adjustment the gun has to be disassembled as described in Section 12 Field Stripping (fig.19). Only adjust
the bolt speed if problems are encountered when firing a different type of ammunition.
For high velocity ammunition, use the correct size Allen wrench (hex key) to reduce the bolt speed by turning
the screw clockwise (fig. 19).
For standard ammunition, use the correct size Allen wrench (hex key) to increase the bolt speed by turning
the screw counter clockwise (fig. 19). The screwhead must not rise out of, or be removed from the gun.
11 Mounting an optical sight
To mount an optical sight, the carry handle can be removed by loosing the nuts on the left side of the
carry handle (fig. 20). This will provide a mil-standard rail for mounting of optics.
Always follow the disassembly instructions exactly. Never do anything
beyond what you are specifically instructed to do in this manual. Never alter or modify the parts
in your firearm.
!
WARNING:
Always wear eye protection that is specified for use with firearms, every
time you handle your firearm for cleaning and maintenance.
!
WARNING:
Prior to disassembly, place the manual safety in the safe position, take
out the magazine and check that the firearm is not loaded.
!
WARNING:
12 Field stripping
fig. 20
SETTINGS / MOUNTING AN OPTICAL SIGHT / FIELD STRIPPING