User's Manual

900-0142
Rev 01
xTP Installation and User Guide
Page 16 of 16
Confidential and Proprietary
7. Using a 3/16” Hex wrench, turn the screw at the back of the stanchion clockwise
until the Trim Ring flange is flush against the stanchion’s front wall.
Figure 10.11 – Subassembly Against Stanchion Wall
8. Continue to turn the screw until meeting some additional resistance. At this
point, the screw shoulder has bottomed out in the xTPA.
Figure 10.12 – Screw Shoulder Bottoms Out
9. The installation is complete.