User's Manual

900-0142
Rev 01
xTP Installation and User Guide
Page 14 of 16
Confidential and Proprietary
5.4 Installation Instructions
The xTP was designed to be installed in various stanchion/enclosure designs. For detailed
enclosure/stanchion design rules, refer to Document 900-0143, Stanchion Design
Requirements.
5.4.1 Generic Stanchion Installation
The images below show an show the xTP being installed into a stanchion mock up
showing the front face and back wall to demonstrate the steps involved with installation.
An actual stanchion is a full enclosed, sealed enclosure for the xTP.
To install the xTP Assembly:
1. Ensure that the Trim Ring O-ring is lubricated with Molykote 55.
Figure 10.5 – Lubricating the Trim Ring
2. Plug in the Ethernet and power lead into the ports at the back of the xTPE. The
arrow on the power lead is facing down.
Figure 10.6 – Plugging in the Ethernet and Power Lead
3. Wait for the Ethernet indicator lights to show connection and activity by blinking.
NOTE: It can take over a minute to connect, once the power is plugged in.