Manualshelf

User's Manual

ManualsBrandsWalt Disney Parks and Resorts US ManualsElectronicsxTP-R1G1
78910111213141516
900-0142
Rev 01
xTP Installation and User Guide
Page 13 of 16
Confidential and Proprietary
5 Installation
5.1 Trained Installation and Service Personnel Warning
Warning! Installation and service of this product is to be performed by trained
installation and service personnel only. Read and follow all warning notices and
instructions marked on the product or included in the documentation. Before installing
the product, read the rest of this document and follow specific product instructions.
When installing, the placement of the device must also satisfy the following installation
requirements:
Placement must allow for easily disconnecting the power cord/adapter of the
device from the AC wall-outlet.
Keep the device away from excessive heat and humidity and keep the device
free from vibration and dust.
Installation must at all times conform to local regulations.
Network Connections can be made with either Unshielded Twisted Pair (UTP) or
Shielded Twisted Pair (STP) cabling.
5.2 Electrostatic Discharge Warning
Warning! Wear an anti-static wrist strap or take other suitable measures to prevent
electrostatic discharge when handling this equipment.
5.3 Telecom Warning
Note: This unit is intended for local (intra-building) connections only and is not
designed or evaluated for direct connections to the public telecommunications/cable
distributions systems. Cable and Ethernet connections should be made in accordance to
the National Electrical Code (NEC). For example, one of the following should be true*:
- Cable runs are located in the same building as this unit.
- Cable runs through air between buildings are less than 42m (140ft).
- Cable runs between buildings are directly buried.
- Cable runs between buildings are in underground conduit, where a continuous metallic
cable shield or a continuous metallic conduit containing the cable is bonded to each
building grounding electrode system.
*These options are from the US National Electrical Code, Sections 800.10, 800.12, 800.13, 800.31, 800.32,
800.33, and 800.40.