Product Description
Table Of Contents
- Integration instructions for host product manufact
- 2.3Specific operational use conditions
- 2.4Limited module procedures
- 2.5Trace antenna designs
- 2.6RF exposure considerations
- 2.7Antennas
- 2.8Label and compliance information
- 2.9Information on test modes and additional testing r
- 2.10Additional testing, Part 15 Subpart B disclaimer
- Federal Communication Commission Statement (FCC, U
the host manufacturer will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
2.7 Antennas
Antenna Specification are as follows:
Type: Dual Band
Dipole Antenna
Gain: 2dBi
This device is intended only for host manufacturers under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna;
The module shall be only used with the internal antenna(s) that has been originally tested and certified
with this module. The antenna must be either permanently attached or employa ‘unique’ antenna
coupler.
As long as the conditions above are met, further transmitter test will not be required. However, the
host manufacturer is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).