Install Manual

WALLENSTEIN by EMB Mfg.Z97562 BX52S 3PH AssyManual.120615

Rev # 230615Page 5 of 8

For threaded parts installation, refer to the torque charts in this manual.

6. Remove the PTO shaft from the skid and place in a safe area

7. While some one is holding the discharge chute:

• carefully remove the 4 nuts & bolts that hold the discharge chute to the shipping bracket.

(this hardware is not needed and can be discarded)

• Set the discharge chute aside in a save place for later assembly

• keep the spacer and hood capture rings with the discharge chute assembly

8. Next while some one is steadying the hopper assembly:

• carefully remove the two bolts that hold the hopper shipping bracket, (keep this hardware,

it is needed to mound the hopper to the chipper body)

• release the folded hopper spring latch, tilt the hopper forward slightly and remove the hopper

shipping bracket