Install Manual

1.0 ASSEMBLY SAFETY
1. Read and understand the Assembly Manual and all safety signs before starting.
2. Follow good safety practices:
- Keep service area clean and dry.
- Be sure electrical outlets and tools are properly grounded.
- Use adequate light for the job at hand.
3. Use properly sized tools, stands, jacks and hoists at all times.
4. Don’t' handle heavy and/or bulky components alone, ask for help.
5. Position in a large open area to allow access from all sides during assembly.
6. Keep the assembly area neat and clean to prevent slipping or tripping.
7. When using lifting equipment, place jack stands under the machine to securely stabilize it
before working on, beside or under it during assembly.
8. Stay away from overhead power lines and obstructions when lifting the machine during as-
sembly. Contact with power lines can cause electrocution. Contact with obstructions can
damage components or cause them to fail.
9. Tightenallfastenerstotheirspeciedtorque,thenrecheckbeforeusingthemachine.
ENGLISH TORQUE SPECIFICATIONS
SAE 2
(N.m) (lb-ft)
Bolt Torque*
Bolt
Diameter
"A"
SAE 5
(N.m) (lb-ft)
SAE 8
(N.m) (lb-ft)
1/4"
5/16"
3/8"
7/16"
1/2"
9/16"
5/8"
3/4"
7/8"
1"
8
13
27
41
61
95
128
225
230
345
6
10
20
30
45
60
95
165
170
225
12
25
45
72
110
155
215
390
570
850
9
19
33
53
80
115
160
290
420
630
17
36
63
100
155
220
305
540
880
1320
12
27
45
75
115
165
220
400
650
970
Torqueguresindicatedabovearevalidfornon-greasedornon-oiledthreadsandheadsunlessoth-
erwisespecied.Therefore,donotgreaseoroilboltsorcapscrewsunlessotherwisespeciedinthis
manual. When using locking elements, increase torque values by 5%.
*Torquevalueforboltsandcapscrewsareidentiedbytheirheadmarkings.
2.0 BOLT TORQUE
WALLENSTEIN by EMB Mfg.Z97562 BX52S 3PH AssyManual.120615
Rev # 230615Page 2 of 8
For threaded parts installation, refer to the torque charts in this manual.